Graders are the last machine on the road job — their work is visible, and a wrong spec shows every day. Three decisions size a grader correctly.
1. Moldboard size and weight class
The moldboard does the work; the operating weight gives the blade its bite.
| Class | Weight | Moldboard | Typical work |
|---|---|---|---|
| 915F / 917F / 919F | 15 – 19 t | 3,660 – 3,974 mm | Rural road maintenance, final trim, ditch cutting |
| 920F / 922F | 20 – 22 t | 3,974 – 4,279 mm | Highway subgrade, large platforms, mining roads |
On the 920F/922F, the blade section is 610 mm × 20 mm with 715 mm max penetration — the heavier section resists distortion when grading hard-packed gravel.
2. All-wheel drive: when it is worth the option
AWD (922F AWD) matters on soft underfoot conditions, mountain roads and wet-season maintenance. If your sites are firm and drained, the standard rear-drive machine is more cost-effective.
3. Hydraulics: load-sensing for fine work
Load-sensing hydraulics deliver full blade control precision at low engine rpm — less fuel, smoother finish, less operator fatigue. Both our ranges use load-sensing as standard; the 280 L fuel tank on the 920F supports long highway shifts between refuels.
4. Spare parts reality check
Graders run long hours on remote roads. Order the first-year wear kit (blade edges, circle teeth, drive chain spares) with the machine — air-freighting a blade edge later costs multiples of the parts price. Our standard support: common wear parts in stock in Weifang, air freight within days.
Not sure between the 915F and 920F class? Tell us the road type and annual maintenance kilometres — we will size it and quote CIF.